DESCRIPTION When the automatic high beam system is on, the main body ECU (multiplex network body ECU) illuminates the auto high beam switch indicator. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
PROCEDURE
(a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Main Body / Active Test. (e) Perform the Active Test according to the display on the Techstream. Body Electrical > Main Body > Active Test
OK: Auto high beam switch indicator light illuminates.
(a) Remove the auto high beam switch. Click here (b) Inspect the auto high beam switch. Click here
(a) Measure the voltage according to the value(s) in the table below. Standard Voltage:
(a) Disconnect the G32 main body ECU (multiplex network body ECU) connector. (b) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Blind Spot Monitor System(for Gasoline Model): Parts Location
PARTS LOCATION ILLUSTRATION *1 OUTER REAR VIEW MIRROR ASSEMBLY LH *2 OUTER REAR VIEW MIRROR ASSEMBLY RH *3 BRAKE ACTUATOR ASSEMBLY - SKID CONTROL ECU *4 ECM *5 OUTER MIRROR CONTROL ECU ASSEMBLY LH (w/ Seat Memory) *6 OUTER MIRROR CONTROL ECU ASSEMBLY RH (w/ Seat Memory) ILLUSTRATION *1 OUTER MIRROR ...