On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT H-LP LH RELAY
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the H-LP LH relay. 2. INSPECT H-LP RH RELAY
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the H-LP RH relay. 3. INSPECT DIM RELAY (w/o Cornering Light)
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the DIM relay. 4. INSPECT DRL RELAY (w/o Cornering Light)
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the DRL relay. |
Toyota Avalon Service & Repair Manual > Smart Key System(for Start Function, Gasoline Model): Check For Intermittent Problems
CHECK FOR INTERMITTENT PROBLEMS NOTICE: Operation history is stored in the RAM or EEPROM of the certification ECU (smart key ECU assembly). As the cause of a malfunction stored in the RAM will be cleared when the cable is disconnected from the negative (-) battery terminal, do not disconnect the cab ...