INSTALLATION PROCEDURE 1. INSTALL STEERING WHEEL SWITCH HOUSING (a) When reusing the steering wheel switch housing:
(2) While holding the clamp expanded, engage the claw as shown in the illustration.
(b) When installing a new steering wheel switch housing:
(2) Engage the claw as shown in the illustration.
(3) Remove the pin to install the steering wheel switch housing as shown in the illustration.
2. INSTALL TURN SIGNAL SWITCH Click here 3. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY Click here 4. INSTALL TILT AND TELESCOPIC SWITCH (for Power Tilt and Power Telescopic Steering Column) Click here 5. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY Click here |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Rear Combination Light Assembly: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL REAR COMBINATION LIGHT ASSEMBLY (a) Engage the grommet. (b) Engage the 3 guides and pin to temporarily install the rear combination light as ...