DESCRIPTION If the manual up and down functions operate normally but the auto up and down functions do not, the power window control system may be in fail-safe mode. If power window initialization has not been performed, the auto up and down functions will not operate. Click here WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
HINT: If the pulse sensor built into the power window regulator motor assembly (for driver door) is malfunctioning, the power window control system will enter fail-safe mode. The remote up and down and auto up and down functions cannot be operated during fail-safe mode. However, the power window can be closed by holding the multiplex network master switch assembly at the auto up position, and opened manually by pushing down the multiplex network master switch assembly. Click here PROCEDURE
(a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Master switch / Data List. (e) Read the Data List according to the display on the Techstream. Body Electrical > Master Switch > Data List
OK: On the Techstream screen, ON or OFF is displayed accordingly.
(a) Enter the following menus: Body Electrical / D-Door Motor / Data List. (b) Read the Data List according to the display on the Techstream. Body Electrical > D-Door Motor > Data List
OK: On the Techstream screen, ON or OFF is displayed accordingly.
(a) Initialize the power window regulator motor assembly (for driver door). Click here
(a) Check that the driver door power window moves when the auto up and down functions of the multiplex network master switch assembly are operated. Click here OK: Driver door auto up and down functions are normal.
(a) Replace the multiplex network master switch assembly. Click here
(a) Check that the driver door power window moves when the auto up and down functions of the multiplex network master switch assembly are operated. Click here OK: Driver door auto up and down functions are normal.
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Dynamic Radar Cruise Control System(for Hv Model): Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: Before replacing the hybrid vehicle control ECU, refer to Registration. Click here When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information store ...