REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during antenna cord sub-assembly removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing. Click here Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model)
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing. Click here PROCEDURE 1. REMOVE INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY Click here 2. REMOVE NO. 1 SIDE DEFROSTER NOZZLE DUCT Click here 3. REMOVE NO. 2 SIDE DEFROSTER NOZZLE DUCT Click here 4. REMOVE DEFROSTER NOZZLE ASSEMBLY Click here 5. REMOVE NO. 3 HEATER TO REGISTER DUCT SUB-ASSEMBLY Click here 6. REMOVE NO. 4 ANTENNA CORD SUB-ASSEMBLY
(b) Disengage the 2 claws.
7. REMOVE ROOF HEADLINING ASSEMBLY Click here 8. REMOVE NO. 3 ANTENNA CORD SUB-ASSEMBLY (a) Remove the adhesive tape from the roof headlining assembly. for Normal Roof:
for Moon Roof:
(b) Remove the No. 3 antenna cord sub-assembly from the roof headlining assembly. 9. REMOVE NO. 2 ANTENNA CORD SUB-ASSEMBLY (w/ Manual (SOS) Switch)
(b) Disengage the 4 clamps to remove the No. 2 antenna cord sub-assembly. |
Toyota Avalon Service & Repair Manual > Electronically Controlled Brake System(for Gasoline Model): Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE OPERATION If there is a problem with sensor signals or actuator systems, the skid control ECU prohibits power supply to the brake actuator assembly and informs the ECM of a VSC system malfunction. The brake actuator assembly turns off the solenoids and the ECM stops its VSC ...