Toyota Avalon Service & Repair Manual: Removal

REMOVAL

PROCEDURE

1. PRECAUTION

(a) w/o Navigation System:

NOTICE:

  • When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
    • A communication malfunction DTC may be stored.
    • The radio and display receiver assembly may not operate normally.

(b) w/ Navigation System:

NOTICE:

  • When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur:
    • A communication malfunction DTC may be stored.
    • The radio and display receiver assembly or navigation ECU may not operate normally.
  • After replacing the radio and display receiver assembly, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the navigation ECU.

2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH

Click here

3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL RH

Click here

4. REMOVE FRONT CONSOLE UPPER PANEL GARNISH

Click here

5. REMOVE CONSOLE BOX POCKET SUB-ASSEMBLY

Click here

6. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

Click here

7. REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL

Click here

8. REMOVE CENTER NO. 2 INSTRUMENT CLUSTER FINISH PANEL

Click here

9. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET

(a) Remove the 4 bolts.

(b) Pull the radio and display receiver assembly with bracket toward the rear of the vehicle to disengage the 5 clips.

Remove in this Direction

(c) Disconnect each connector and remove the radio and display receiver assembly with bracket.

10. REMOVE INTERIOR ILLUMINATION LIGHT SUB-ASSEMBLY

Click here

11. REMOVE NO. 1 RADIO RECEIVER BRACKET

(a) Remove the 4 screws and No. 1 radio receiver bracket.

12. REMOVE NO. 2 RADIO RECEIVER BRACKET

(a) Remove the 4 screws and No. 2 radio receiver bracket.

13. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

(a) Disengage the 8 claws and remove the No. 2 instrument panel register assembly as shown in the illustration.

Remove in this Direction

14. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY

    Installation

    Rear Door Speaker

    See More:

    Toyota Avalon Service & Repair Manual > Brake Pedal(for Gasoline Model): Adjustment
    ADJUSTMENT PROCEDURE 1. INSPECT AND ADJUST BRAKE PEDAL HEIGHT (a) Remove the front door scuff plate LH. Click here (b) Remove the cowl side trim sub-assembly LH. Click here (c) Remove the No. 1 instrument panel under cover sub-assembly. Click here (d) Remove the accelerator pedal pad. Click here (e) ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.028