REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during level warning switch assembly removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY Click here 2. DRAIN WASHER FLUID Click here 3. REMOVE LEVEL WARNING SWITCH ASSEMBLY (a) Disconnect the connector.
(b) Remove the level warning switch assembly as shown in the illustration. |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Electronically Controlled Brake System(for Gasoline Model): Malfunction in Yaw Rate Sensor (C1436)
DESCRIPTION This DTC is stored when the skid control ECU (brake actuator assembly) detects improper installation of the yaw rate and acceleration sensor (airbag sensor assembly) or an abnormality in the difference between the yaw rate sensor value and the control value estimated based on the acceler ...