Components COMPONENTS ILLUSTRATION
Inspection INSPECTION PROCEDURE 1. INSPECT WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY
(a) Remove the washer jar. (b) Disconnect the windshield washer motor and pump assembly connector. HINT: This check should be performed with the windshield washer motor and pump assembly installed on the washer jar. (c) Fill the washer jar with washer fluid. (d) Connect an auxiliary battery positive (+) lead to terminal 1 of the windshield washer motor and pump assembly, and a negative (-) lead to terminal 2. (e) Check that washer fluid flows from the washer jar. OK: Washer fluid flows from the washer jar. If the result is not as specified, replace the windshield washer motor and pump assembly. Installation INSTALLATION PROCEDURE 1. INSTALL WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY (a) Install the windshield washer motor and pump assembly as shown in the illustration.
(b) Connect the connector. 2. ADD WASHER FLUID (a) Connect the washer hose. (b) Add washer fluid to the washer jar. 3. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH (a) Install the front fender splash shield sub-assembly RH with the 11 clips and 6 screws. (b) Install the 2 clips. 4. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH (a) Install the front wheel opening extension pad RH with the 3 screws. 5. INSTALL FRONT WHEEL RH Click here Removal REMOVAL PROCEDURE 1. REMOVE FRONT WHEEL RH Click here 2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
3. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
4. DRAIN WASHER FLUID
5. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY (a) Disconnect the connector.
(b) Remove the windshield washer motor and pump assembly as shown in the illustration. |
Toyota Avalon Service & Repair Manual > Motor Generator Control System: DC/DC Converter Enable Component Internal Failure (P1CCC96)
DESCRIPTION The DC/DC converter converts the DC 244.8 V of the HV battery into DC 12 V in order to supply power to areas such as the vehicle lighting system, audio system and various ECUs. Additionally, it charges the auxiliary battery. A transistor bridge circuit initially converts DC 244.8 V into ...