DESCRIPTION When the washer fluid level is lower than a certain level, a warning message is displayed on the combination meter assembly. WIRING DIAGRAM PROCEDURE
(a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Combination Meter / Data List. (e) Read the Data List according to the display on the Techstream. Body Electrical > Combination Meter > Data List
OK: The Techstream display changes correctly in response to the washer fluid level.
(a) Remove the level warning switch assembly. Click here (b) Inspect the level warning switch assembly. Click here
(a) Disconnect the G16 combination meter assembly connector. (b) Measure the resistance according to the value(s) in the table below. Standard Resistance:
(a) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
Toyota Avalon Service & Repair Manual > Electronically Controlled Brake System(for Hv Model): Open Circuit in Main Relay 1 (C1311,C1312)
DESCRIPTION The main relay supplies power to the switching solenoid and the linear solenoid. The main relay remains on for approximately 2 minutes after the power switch is turned off and the input of brake pedal operation signals stops, and supplies power to the system to keep it ready to operate. ...