REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during telephone antenna assembly removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing. Click here
![]()
CAUTION: Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing. Click here
![]() PROCEDURE 1. REMOVE ROOF HEADLINING ASSEMBLY Click here
2. REMOVE TELEPHONE ANTENNA ASSEMBLY WITH COVER
(c) Remove the washer and holder as shown in the illustration. ![]()
(d) Remove the telephone antenna assembly with cover as shown in the illustration. ![]()
3. REMOVE TELEPHONE ANTENNA ASSEMBLY (a) Pull the telephone antenna assembly in the direction indicated by the arrow (1) shown in the illustration to disengage the 3 claws and 2 guides. ![]()
(b) Pull the telephone antenna assembly in the direction indicated by the arrow (2) shown in the illustration to disengage the guide and remove the telephone antenna assembly. (c) When reusing the telephone antenna assembly:
|
Toyota Avalon Service & Repair Manual > Blind Spot Monitor System(for Gasoline Model): Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the blind spot monitor system on. (d) Turn the Techstream on. (e) Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Codes. HINT: ...