DESCRIPTION The combination meter assembly receives signals through this circuit to adjust the illumination of the combination meter assembly. The combination meter assembly sets the illumination level based on the user operation of the light control rheostat switch in the trip switch. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored. HINT:
PROCEDURE
(a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Combination Meter / Data List. (e) Read the Data List according to the display on the Techstream. Body Electrical > Combination Meter > Data List
OK: Light control rheostat up or down switch (trip switch) condition displayed on the Techstream changes with the actual switch operation.
(a) Remove the trip switch. Click here (b) Inspect the trip switch. Click here
(a) Disconnect the G15 combination meter assembly connector. (b) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Intuitive Parking Assist System(for Gasoline Model): Front Left Sensor Malfunction (C1AE1)
DESCRIPTION The front corner ultrasonic sensor LH is installed to the front bumper. The clearance warning ECU assembly detects obstacles based on signals received from the front corner ultrasonic sensor LH. If the front corner ultrasonic sensor LH has an open circuit or other malfunction, it will no ...