Toyota Avalon Service & Repair Manual: Dcm Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the DCM (Telematics Transceiver).

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (DCM (TELEMATICS TRANSCEIVER) - BATTERY AND GROUND)

(a) Disconnect the G9 DCM (Telematics Transceiver) connector.

*a

Front view of wire harness connector

(to DCM (Telematics Transceiver))

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

G9-4 (E) - Body ground

Always

Below 1 Ω

(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

G9-1 (+B) - G9-4 (E)

Always

11 to 14 V

G9-7 (IG2) - G9-4 (E)

Engine switch on (IG)

11 to 14 V

G9-8 (ACC) - G9-4 (E)

Engine switch on (ACC)

11 to 14 V

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

    Dcm Operation History

    Diagnosis System

    See More:

    Toyota Avalon Service & Repair Manual > Sfi System: Throttle Actuator "A" Control Motor Circuit Short to Ground or Open (P210014,P210015)
    DESCRIPTION The throttle actuator is operated by the ECM and opens and closes the throttle valve using gears. The opening angle of the throttle valve is detected by the throttle position sensor, which is mounted on the throttle body with motor assembly. The throttle position sensor provides feedback ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0199