Toyota Avalon Service & Repair Manual: Front Airbag Sensor (LH) (B1615)

DESCRIPTION

The front airbag sensor LH circuit consists of the airbag ECU assembly and front airbag sensor LH.

The front airbag sensor LH detects impacts to the vehicle and sends signals to the airbag ECU assembly to determine if the airbags and pretensioners should be deployed.

DTC B1615 is stored when a malfunction is detected in the front airbag sensor LH.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Warning Indicate

Test Mode / Check Mode

B1615

Front Airbag Sensor (LH)

  • Front airbag sensor LH malfunction
  • Airbag ECU assembly malfunction
  • Front airbag sensor LH
  • Airbag ECU assembly

Comes on

Does not apply to test/check mode

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here

PROCEDURE

1.

CHECK FRONT AIRBAG SENSOR LH

(a) Turn the engine switch off.

*1

Front Airbag Sensor RH

*2

Airbag ECU Assembly

(b) Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Interchange the front airbag sensor LH with RH and connect the connectors.

(d) Connect the cable to the negative (-) battery terminal.

(e) Turn the engine switch on (IG), and wait for at least 60 seconds.

(f) Clear the DTCs stored in memory.

Body Electrical > SRS Airbag > Clear DTCs

(g) Turn the engine switch off.

(h) Turn the engine switch on (IG), and wait for at least 60 seconds.

(i) Check for DTCs.

Body Electrical > SRS Airbag > Trouble Codes

HINT:

Codes other than DTCs B1610 and B1615 may be output at this time, but they are not related to this check.

Result

Proceed to

DTCs B1610 and B1615 are not output.

A

DTC B1615 is output.

B

DTC B1610 is output.

C

(j) Turn the engine switch off.

(k) Disconnect the cable from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(l) Return the front airbag sensor LH and RH to their original positions and connect the connectors.

A

USE SIMULATION METHOD TO CHECK

B

REPLACE AIRBAG ECU ASSEMBLY

C

REPLACE FRONT AIRBAG SENSOR LH

    Front Airbag Sensor Lost Communication (RH) (B1612,B1613)

    Front Airbag Sensor Lost Communication (LH) (B1617,B1618)

    See More:

    Toyota Avalon Service & Repair Manual > Engine Oil Temperature Sensor: Installation
    INSTALLATION PROCEDURE 1. INSTALL ENGINE OIL TEMPERATURE SENSOR (a) Install a new gasket to the engine oil temperature sensor. (b) Using SST, install the engine oil temperature sensor to the cylinder block sub-assembly. SST: 09817-33191 Torque: 19.6 N·m {200 kgf·cm, 14 ft·lbf} NOTICE: If the engi ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.012