DESCRIPTION The occupant detection ECU receives signals from the acceleration sensor (airbag ECU assembly) and skid control ECU (brake booster with master cylinder assembly) via CAN communication.
CAUTION / NOTICE / HINT NOTICE: After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work. Click here HINT:
PROCEDURE
(a) Check for electronically controlled brake system DTCs. Click here OK: DTCs are not output.
(a) Using the Techstream, check if the CAN communication system is functioning normally. OK: CAN communication system is functioning normally. HINT: Refer to Communication Bus Check in CAN Communication System. Click here
(a) Turn the power switch off. (b) Connect the Techstream to the DLC3. (c) Turn the power switch on (IG) and turn the Techstream on. (d) Enter the following menus: System Select / Health Check. OK: DTCs are not output.
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Sfi System: ACIS Control Circuit
DESCRIPTION ACIS (Acoustic Control Induction System) controls the opening and closing the intake air control valve sub-assembly built into the intake air surge tank assembly to increase the intake efficiency according to the engine load. When the engine speed is between 0 and 4300 rpm and the thrott ...