INSTALLATION PROCEDURE 1. INSTALL NO. 1 INDOOR ELECTRICAL KEY ANTENNA ASSEMBLY (a) Engage the clamp to install the No. 1 indoor electrical key antenna assembly. NOTICE: Be careful when installing the No. 1 indoor electrical key antenna assembly. If the No. 1 indoor electrical key antenna assembly is dropped, replace it with a new one. (b) Connect the connector. 2. INSTALL REAR SEAT CUSHION LOCK HOOK Click here 3. INSTALL REAR SEAT CUSHION ASSEMBLY Click here 4. CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY Click here 5. INSTALL LUGGAGE COMPARTMENT INNER TRIM PAD (w/ Seat Heater System) Click here 6. INSTALL SPARE WHEEL COVER ASSEMBLY (w/ Seat Heater System) Click here 7. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL for A25A-FXS: Click here for 2GR-FKS: Click here 8. INSTALL LUGGAGE TRIM SERVICE HOLE COVER (for HV Model) Click here 9. PERFORM DIAGNOSTIC SYSTEM CHECK for Gasoline Model: Click here for HV Model: Click here |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Electronically Controlled Brake System(for Hv Model): Open in Stop Switch Circuit (C1425,P0573)
DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) detects the brake operating conditions through a signal transmitted by the stop light switch assembly. The skid control ECU incorporates a circuit to detect an open circuit. This DTC is output when an open circuit is dete ...