PRECAUTION PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
- After the engine switch is turned off, the radio and display receiver
assembly records various types of memory and settings. As a result,
after turning the engine switch off, make sure to wait at least 85
seconds before disconnecting the cable from the negative (-) battery
terminal.
- When disconnecting the cable from the negative (-) battery terminal,
initialize the following systems after the terminal is reconnected.
|
System Name |
See Procedure |
|
Lane Departure Alert System (w/ Steering Control) |
|
|
Intelligent Clearance Sonar System |
|
Parking Assist Monitor System |
|
Panoramic View Monitor System |
|
Pre-collision System |
|
Lighting System (for Gasoline Model with Cornering Light)
|
PRECAUTION FOR NAVIGATION SYSTEM
NOTICE:
- When replacing the radio and display receiver assembly or navigation
ECU, always replace it with a new one. If a radio and display receiver
assembly or navigation ECU which was installed to another vehicle is
used, the following may occur:
- A communication malfunction DTC may be stored.
- The radio and display receiver assembly or navigation ECU may not operate normally.
- When performing the following work, the navigation system may restart
when turning the engine switch on (ACC) (due to radio and display
receiver assembly and navigation ECU certification).
- Repair or replace the negative (-) battery terminal due to it being disconnected or depleted.
- The radio and display receiver assembly or navigation ECU replacement or removal and installation.
- When replacing the DCM (telematics transceiver), make sure to replace it with a new one (w/ Manual (SOS) Switch).
- After replacing the radio and display receiver assembly, if "New
software is not compatible with the system. Contact your dealer." is
displayed on the multi-display, update the software of the navigation
ECU.
- After replacing the navigation ECU, if "New software is not compatible
with the system. Contact your dealer." is displayed on the
multi-display, update the software of the radio and display receiver
assembly.
(a) If any of the following parts are replaced, refer to Initialization in Repair Instruction.
Click here
- Radio and display receiver assembly*1
- DCM (telematics transceiver)*2
|
