Toyota Avalon Service & Repair Manual: Radio Receiver Power Source Circuit

Toyota Avalon Service & Repair Manual / Audio, Visual, Telematics / Navigation / Multi Info Display / Navigation System(for Gasoline Model) / Radio Receiver Power Source Circuit

DESCRIPTION

This is the power source circuit to operate the radio and display receiver assembly.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY POWER SOURCE)

(a) Disconnect the G3 and G2 radio and display receiver assembly connectors.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

G3-1 (GND1) - Body ground

Always

Below 1 Ω

(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

G3-4 (+B1) - G3-1 (GND1)

Always

11 to 14 V

G3-15 (ACC1) - G3-1 (GND1)

Engine switch on (ACC)

11 to 14 V

G2-19 (IG) - G3-1 (GND1)

Engine switch on (IG)

11 to 14 V
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR
    Radio Broadcast cannot be Received or Poor Reception

    Registered Device cannot be Deleted

    See More:

    Toyota Avalon Service & Repair Manual > Fuel Pump(for High Pressure): On-vehicle Inspection
    ON-VEHICLE INSPECTION PROCEDURE 1. FUEL PUMP ASSEMBLY OPERATION (a) Check fuel pressure. (1) Connect the Techstream to the DLC3. (2) Start the engine. (3) Turn the Techstream on. (4) Enter the following menus: Powertrain / Engine / Active Test / Control the Target Fuel Pressure Offset. Powertrain &g ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2022 Copyright www.tavalon.net
    0.0106