Toyota Avalon Service & Repair Manual: Reverse Signal Circuit

DESCRIPTION

The radio and display receiver assembly receives a reverse signal from the BKUP LP relay.

WIRING DIAGRAM

PROCEDURE

1.

CHECK BACK-UP LIGHT

(a) Move the shift lever to R and check if the back-up lights come on.

OK:

The back-up lights come on.

NG

GO TO LIGHTING SYSTEM

OK

2.

CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)

(a) Disconnect the G3 radio and display receiver assembly connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

G3-28 (REV) - Body ground

Engine switch on (IG)

Shift lever in R

11 to 14 V

G3-28 (REV) - Body ground

Engine switch on (IG)

Shift lever not in R

Below 1 V

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

    Reverse Signal Circuit between Radio Receiver Assembly and Navigation ECU

    Route cannot be Calculated

    See More:

    Toyota Avalon Service & Repair Manual > Front Camera System(for Hv Model): Yaw Rate Sensor Circuit (C1AA4,C1AA5)
    DESCRIPTION The forward recognition camera receives vehicle stability signals from the yaw rate sensor (airbag ECU assembly). If the yaw rate sensor (airbag ECU assembly) detects an abnormal yaw rate sensor signal or yaw rate sensor power supply voltage, it informs the forward recognition camera via ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0163