DESCRIPTION The blind spot monitor sensor receives steering angle signals from the steering sensor via CAN communication. Blind Spot Monitor Master
CAUTION / NOTICE / HINT NOTICE: When checking for DTCs, make sure that the blind spot monitor system is turned on. PROCEDURE
(a) Turn the engine switch off. (b) Turn the engine switch on (IG). (c) Recheck for DTCs and check if the same DTC is output again. Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble CodesOK: No DTCs are output.
(a) Replace the steering sensor with a new or known good one. Click here
(a) Turn the engine switch off. (b) Turn the engine switch on (IG). (c) Recheck for DTCs and check if the same DTC is output again. Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Hybrid Control System: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Hybrid Control System DTC No. Detection Item MIL Warning Indicate Link P056014 System Voltage (BATT) Circuit Short to Ground or Open Comes on Master Warning Light: Comes on P060647 Hybrid/EV Powertrain Control Module Processor Watchdog / Safety MCU Failure Comes on Mast ...