Toyota Avalon Service & Repair Manual: Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)

DESCRIPTION

This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH.

HINT:

This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1ABB

Blind Spot Monitor Master Module Beam Axis Inspection Incomplete

A beam axis inspection has not been performed

Blind spot monitor sensor RH

PROCEDURE

1.

PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION)

(a) Change the blind spot monitor sensor RH to Test Mode using the Techstream.

HINT:

Refer to Blind Spot Monitor Beam Axis Inspection.

Click here

NEXT

END

    Destination Information Undefined (C1AB8)

    Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)

    See More:

    Toyota Avalon Service & Repair Manual > Sfi System: Engine Oil Temperature Sensor Circuit Short to Battery or Open (P019515)
    DESCRIPTION Refer to DTC P019511. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P019515 Engine Oil Temperature Sensor Circuit Short to Battery or Open The engine oil temperature sensor output voltage is higher than 4.94 V for 5 seconds or more (1 trip detecti ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2022 Copyright www.tavalon.net
    0.0107