Toyota Avalon Service & Repair Manual: Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)

DESCRIPTION

This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor LH.

HINT:

This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1ABC

Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete

A beam axis inspection has not been performed

Blind spot monitor sensor LH

PROCEDURE

1.

PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION)

(a) Change the blind spot monitor sensor LH to Test Mode using the Techstream.

HINT:

Refer to Blind Spot Monitor Beam Axis Inspection.

Click here

NEXT

END

    Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)

    Short to GND or Open in Buzzer (C1ABE)

    See More:

    Toyota Avalon Service & Repair Manual > Sliding Roof System(for Gasoline Model): Switch Failure (B2342)
    DESCRIPTION This DTC is stored when the sliding roof ECU (sliding roof drive gear assembly) detects that the sliding roof switch (roof console box sub-assembly) is stuck for 30 seconds or more. DTC No. Detection Item DTC Detection Condition Trouble Area B2342 Switch Failure Sliding roof ECU (sliding ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0187