Toyota Avalon Service & Repair Manual: Lost Communication with Blind Spot Monitor Master Module (U0233)

DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH judges that there is a communication problem with the blind spot monitor sensor RH.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

U0233

Lost Communication with Blind Spot Monitor Master Module

The blind spot monitor sensor (slave) cannot receive signals from the blind spot monitor sensor (master)

  • Blind spot monitor sensor RH
  • Blind spot monitor sensor LH
  • Wire harness or connector

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor system is turned on.

HINT:

  • Operating the engine switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
  • Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.

PROCEDURE

1.

CHECK DTC OUTPUT

(a) Turn the engine switch off.

(b) Turn the engine switch on (IG).

(c) Clear the DTCs.

Body Electrical > Blind Spot Monitor Slave > Clear DTCs

(d) Check for DTCs.

Body Electrical > Blind Spot Monitor Slave > Trouble Codes

Result

Proceed to

DTC U0233 is output

A

No DTCs are output

B

B

USE SIMULATION METHOD TO CHECK

A

2.

REPLACE BLIND SPOT MONITOR SENSOR RH

Click here

NEXT

3.

CHECK DTC OUTPUT

(a) Check for DTCs.

Body Electrical > Blind Spot Monitor Slave > Trouble Codes

Result

Proceed to

DTC U0233 is output

A

No DTCs are output

B

A

REPLACE BLIND SPOT MONITOR SENSOR LH

B

END (BLIND SPOT MONITOR SENSOR RH WAS DEFECTIVE)

    Lost Communication with Blind Spot Monitor Slave Module (U0232)

    Software Incompatibility with Body Control Module "B" (U1331)

    See More:

    Toyota Avalon Service & Repair Manual > Cylinder Head: Replacement
    REPLACEMENT CAUTION / NOTICE / HINT HINT: Use the same procedure for bank 1 and bank 2. The following procedure is for bank 2. PROCEDURE 1. REPLACE INTAKE VALVE GUIDE BUSH (a) Heat the cylinder head LH to between 80 and 100°C (176 and 212°F). (b) Place the cylinder head LH on wooden blocks. CAUTIO ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2022 Copyright www.tavalon.net
    0.0171