Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Data List / Active Test

DATA LIST / ACTIVE TEST

DATA LIST

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Advanced Parking Guidance/ICS/Intuitive P/A / Data List.

(e) Read the Data List according to the display on the Techstream.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

ICS SW Status

Intelligent clearance sonar system switch assembly (Multi-information switch)

OFF or ON

OFF: Intelligent clearance sonar system off

ON: Intelligent clearance sonar system on

-

Fr Sensor Onset Range

Detection operation range (for front center sensors)

Narrow or Wide

Narrow: 600 mm (23.6 in.)

Wide: 1000 mm (39.4 in.)

Customized value displayed

Rr Sensor Onset Range

Detection operation range (for rear center sensors)

Narrow or Wide

Narrow: 600 mm (23.6 in.)

Wide: 1500 mm (59.1 in.)

Customized value displayed

Keep Sense Buzzer

Keep sense buzzer operation

Not Avail or Avail

Not Avail: Buzzer stops

Avail: Buzzer sounds continuously

Customized value displayed

Fr & Rr Buzzer Volume

Buzzer volume setting

L, M or H

L: Low volume

M: Medium volume

H: High volume

Customized value displayed

Sensor Condition N

Front sensor operation

Not Avail or Avail

Not Avail: Front sensors not available

Avail: Front sensors available

Customized value displayed

Approach Display OFF

Whether the display turns off after an obstacle is no longer detected.

Not Avail or Avail

Not Avail: Not displayed

Avail: Displayed

Customized value displayed

BSM Radar Communication Invalid History

BSM radar communication invalid history

Yes or No

Yes: History stored

No: History not stored

-

Target 1 Distance (FLC Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 7.65 m (0.00 to 25.09 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance

-

Target 1 Distance (FRC Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 7.65 m (0.00 to 25.09 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance

-

Target 1 Distance (RLC Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 7.65 m (0.00 to 25.09 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance

-

Target 1 Distance (RRC Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 7.65 m (0.00 to 25.09 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance

-

Target 1 Distance (FL Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 5.10 m

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 5.10 m (0.00 to 16.73 ft.): Detected distance

-

Target 1 Distance (FR Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 5.10 m (0.00 to 16.73 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 5.10 m (0.00 to 16.73 ft.): Detected distance

-

Target 1 Distance (RL Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 5.10 m (0.00 to 16.73 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 5.10 m (0.00 to 16.73 ft.): Detected distance

-

Target 1 Distance (RR Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 5.10 m (0.00 to 16.73 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 5.10 m (0.00 to 16.73 ft.): Detected distance

-

Target 2 Distance (FLC Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 7.65 m

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance

-

Target 2 Distance (FRC Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 7.65 m (0.00 to 25.09 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance

-

Target 2 Distance (RLC Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 7.65 m (0.00 to 25.09 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance

-

Target 2 Distance (RRC Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 7.65 m (0.00 to 25.09 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 7.65 m (0.00 to 25.09 ft.): Detected distance

-

Target 2 Distance (FL Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 5.10 m (0.00 to 16.73 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 5.10 m (0.00 to 16.73 ft.): Detected distance

-

Target 2 Distance (FR Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 5.10 m (0.00 to 16.73 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 5.10 m (0.00 to 16.73 ft.): Detected distance

-

Target 2 Distance (RL Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 5.10 m (0.00 to 16.73 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 5.10 m (0.00 to 16.73 ft.): Detected distance

-

Target 2 Distance (RR Sensor)

Distance between ultrasonic sensor and target object

Unknown, Not Detected or 0.00 to 5.10 m (0.00 to 16.73 ft.)

Unknown: Detection conditions not met

Not Detected: No objects detected

0.00 to 5.10 m (0.00 to 16.73 ft.): Detected distance

-

ICS Function

Current setting of intelligent clearance sonar system

ON or OFF

ON: Intelligent clearance sonar system enabled

OFF: Intelligent clearance sonar system disabled

Customized value displayed

ICS System

Existence of intelligent clearance sonar system

Without or With

Without: w/o Intelligent clearance sonar system

With: w/ Intelligent clearance sonar system

-

ICS Stop Distance

Target stop distance

Short or Long

Short: Near

Long: Far

Customized value displayed

ICS SW Status Memory

Setting that determines if the on/off operation state when the engine switch is turned off is resumed when the engine switch is turned on

Yes or No

Yes: Previous on/off operation state is resumed

No: System operates when the engine switch is turned on

Customized value displayed

Bumper Type

Registered bumper type

Unfixed or 1 to 127

1: Bumper for bar type radiator grille

2: Bumper for mesh type radiator grille

3 to 127: Unknown

Unfixed: Unknown

-

RCTAB Function

Setting of the rear traffic auto brake function

ON/OFF

ON: Rear traffic auto brake function ON

OFF: Rear traffic auto brake function OFF

-

RCTAB Operation Timing Setting

Setting of the activation timing of the rear traffic auto brake function

Standard or Late

Late: Late timing

Standard: Standard timing

-

RCTAB Sensitivity

Setting of the sensitivity of the rear traffic auto brake function

Low or Standard

Standard: Standard sensitivity

Low: Low sensitivity

-

# Codes

Number of stored DTCs

min.: 0, max.: 255

Number of DTCs will be displayed

-

ACTIVE TEST

HINT:

Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Chassis / ABS/VSC/TRAC / Active Test.

(e) According to the display on the Techstream, perform the Active Test.

Chassis > ABS/VSC/TRAC > Active Test

Tester Display

Measurement Item

Control Range

Diagnostic Note

Stop Light Relay

Stop lights

ON / OFF

Test possible at vehicle speed of 0 km/h (0 mph)

(f) Enter the following menus: Body Electrical / Combination Meter / Active Test.

(g) According to the display on the Techstream, perform the Active Test.

Body Electrical > Combination Meter > Active Test

Tester Display

Measurement Item

Control Range

Diagnostic Note

ICS OFF Indicator

ICS OFF indicator light

ON / OFF

-

(h) Enter the following menus: Body Electrical / Advanced Parking Guidance/ICS/Intuitive P/A / Active Test.

(i) According to the display on the Techstream, perform the Active Test.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Active Test

Tester Display

Measurement Item

Control Range

Diagnostic Note

Rear Buzzer

No. 1 clearance warning buzzer

Stop or Operate

Confirm that the vehicle is stopped and the engine switch is on (IG)

Front/Rear Buzzer

No. 2 clearance warning buzzer

Stop or Operate

Confirm that the vehicle is stopped and the engine switch is on (IG)

    Customize Parameters

    Diagnosis System

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Sfi System: Engine Stalls
    DESCRIPTION Problem Symptom Suspected Area Trouble Area Engine speed fluctuation due to abnormal combustion Idle speed too low or high Strong engine vibration due to above symptoms Ignition malfunction Deviation in air fuel ratio (Excessive or insufficient intake air volume or fuel supply) Insuffici ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0302