DESCRIPTION This DTC is stored if the radio and display receiver assembly judges that the signals or signal lines between the television camera assembly, and the radio and display receiver assembly are not normal as a result of its self check.
WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed. Click here PROCEDURE
(a) Disconnect the G2 radio and display receiver assembly connector. (b) Disconnect the P19 television camera assembly connector. (c) Measure the resistance according to the value(s) in the table below. Standard Resistance:
(a) Reconnect the G2 radio and display receiver assembly connector.
(c) Measure the voltage according to the value(s) in the table below. Standard Voltage:
(a) Reconnect the P19 television camera assembly connector. (b) Using an oscilloscope, check the waveform of the television camera assembly.
HINT: A waterproof connector is used for the television camera assembly. Therefore, inspect the waveform at the radio and display receiver assembly with the connector connected. OK: Waveform is similar to that shown in the illustration.
HINT:
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Electronically Controlled Brake System(for Hv Model): Brake Warning Light does not Come ON
DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) is connected to the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE: After replacing the skid control ECU (brake booster with master cylinder assembly), perform linear solenoid valve offse ...