DESCRIPTION This DTC is
stored if the television camera assembly receives a signal via CAN
communication from the steering sensor that indicates a power supply
problem.
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
C1625 | Open or Short in Steering Angle Sensor +B |
Open or short in steering sensor power source |
- Harness or connector
- Steering sensor
| WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
- Inspect the fuses for circuits related to this system before performing the following procedure.
- Depending on the parts that are replaced or operations that are
performed during vehicle inspection or maintenance, calibration of other
systems as well as the parking assist monitor system may be needed.
Click here
PROCEDURE
1. | CHECK HARNESS AND CONNECTOR (STEERING SENSOR POWER SOURCE) |
(a) Disconnect the G48 steering sensor connector. (b) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Condition |
Specified Condition |
G48-9 (IG1) - G48-6 (ESS) |
Engine switch on (IG) |
11 to 14 V |
NG |
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
OK |
| |
2. |
CHECK HARNESS AND CONNECTOR (STEERING SENSOR POWER SOURCE) |
(a) Disconnect the G48 steering sensor connector. (b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Condition |
Specified Condition |
G48-6 (ESS) - Body ground |
Always | Below 1 Ω |
(c) Measure the voltage according to the value(s) in the table below. Standard Voltage:
Tester Connection | Condition |
Specified Condition |
G48-4 (BAT) - G48-6 (ESS) |
Always | 11 to 14 V |
OK |
| REPLACE STEERING SENSOR |
NG |
| REPAIR OR REPLACE HARNESS OR CONNECTOR | |