Components COMPONENTS ILLUSTRATION 
Inspection INSPECTION PROCEDURE 1. INSPECT BRAKE HOLD SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)
(b) Disconnect the brake hold switch (electric parking brake switch assembly) connector. (c) Check both the connector case and the terminal for deformation and corrosion. OK: No deformation or corrosion. (d) Measure the resistance according to the value(s) in the table below. Standard Resistance:
HINT: If the result is not as specified, replace the brake hold switch (electric parking brake switch assembly). Installation INSTALLATION PROCEDURE 1. INSTALL BRAKE HOLD SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)
(b) Engage the guide and clamp. 2. INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY Click here Removal REMOVAL PROCEDURE 1. PRECAUTION Click here 2. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY Click here 3. REMOVE BRAKE HOLD SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)
(b) Remove the 4 screws and brake hold switch (electric parking brake switch assembly). |
Toyota Avalon Service & Repair Manual > Smart Key System(for Start Function, Hv Model): Open / Short in Steering Lock ECU (B2781)
DESCRIPTION The steering lock ECU and steering lock motor are built into the steering lock actuator or upper bracket assembly. The steering lock ECU (steering lock actuator or upper bracket assembly) detects whether the steering lock is in the lock or unlock position by using the lock sensor and unl ...
