Toyota Avalon Service & Repair Manual: Deceleration Sensor Internal Circuit (C1419,C1435)

DESCRIPTION

These DTCs are stored when the skid control ECU (brake actuator assembly) receives an internal malfunction signal from the yaw rate and acceleration sensor (airbag sensor assembly).

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1419

Deceleration Sensor Internal Circuit

With the +BS terminal voltage between 9.6 and 16.5 V, an acceleration sensor malfunction signal is received from the acceleration sensor.

Acceleration sensor (airbag sensor assembly)

C1435

Yaw Rate Sensor Internal Circuit

With the +BS terminal voltage between 9.6 and 16.5 V, a yaw rate sensor malfunction signal is received from the yaw rate sensor.

Yaw rate sensor (airbag sensor assembly)

CAUTION / NOTICE / HINT

NOTICE:

After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor assembly), perform system variant learning and acceleration sensor zero point calibration.

Click here

PROCEDURE

1.

REPLACE AIRBAG SENSOR ASSEMBLY

(a) Replace the yaw rate and acceleration sensor (airbag sensor assembly).

Click here

NEXT

END

    IG1 Voltage Supply too High (C1417)

    Malfunction in Deceleration Sensor (C1420)

    See More:

    Toyota Avalon Service & Repair Manual > Front Drive Shaft Assembly: Disassembly
    DISASSEMBLY CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. SEPARATE FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP (a) Secure the drive shaft in a vise between aluminum plates. NOTICE: Do not overtighten the vise. ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.029