DESCRIPTION The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE: When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration. Click here
PROCEDURE
(a) Check if CAN communication system DTCs are output. Click here
(a) Enter the following menus: Chassis / ABS/VSC/TRAC/EPB / Active Test. Chassis > ABS/VSC/TRAC/EPB > Active Test
(b) Check the operating condition of the slip indicator light when operating it using the Techstream.
(a) Enter the following menus: Body Electrical / Combination Meter / Active Test. (b) Perform an Active Test of the combination meter assembly using the Techstream. Body Electrical > Combination Meter > Active Test
(c) Check the combination meter assembly. OK: The slip indicator light turns on or off in accordance with Techstream operation.
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Rear Seat Inner Belt Assembly(for Lh Side): Installation
INSTALLATION PROCEDURE 1. INSTALL REAR SEAT INNER BELT ASSEMBLY LH (a) Install the rear seat inner with center belt assembly LH with the bolt. Torque: 42 N·m {428 kgf·cm, 31 ft·lbf} NOTICE: Do not allow the anchor part of the rear seat inner with center belt assembly LH to overlap the protruding ...
