REPLACEMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during automatic transaxle fluid replacement are shown below. Necessary Procedures After Parts Removed/Installed/Replaced
PROCEDURE 1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH Click here
2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH Click here 3. REMOVE NO. 1 ENGINE UNDER COVER Click here 4. REMOVE REAR ENGINE UNDER COVER LH Click here 5. REMOVE FRONT FENDER APRON SEAL LH Click here 6. REPLACE AUTOMATIC TRANSAXLE FLUID Click here 7. ADD SPECIFIED AMOUNT OF AUTOMATIC TRANSAXLE FLUID Click here 8. ADJUST AUTOMATIC TRANSAXLE FLUID TEMPERATURE (when Using the Techstream) Click here 9. ADJUST AUTOMATIC TRANSAXLE FLUID TEMPERATURE (when Not Using the Techstream) Click here 10. ADJUST AUTOMATIC TRANSAXLE FLUID LEVEL Click here 11. REBUILD WORK Click here
12. INSTALL FRONT FENDER APRON SEAL LH Click here 13. INSTALL REAR ENGINE UNDER COVER LH Click here 14. INSTALL NO. 1 ENGINE UNDER COVER Click here 15. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH Click here 16. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH Click here |
Toyota Avalon Service & Repair Manual > Dynamic Radar Cruise Control System(for Gasoline Model): Fail-safe Chart
FAIL-SAFE CHART HINT: If any of the following auto cancel conditions are detected while the dynamic radar cruise control system is controlling vehicle speed, the system clears the stored vehicle speed and cancels control of vehicle speed by the dynamic radar cruise control system. Automatic Cancel C ...