ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (a) Connect the Techstream to the DLC3. (b) Turn the power switch on (IG). (c) Turn the Techstream on. (d) Put the engine in Inspection Mode (Maintenance Mode). Powertrain > Hybrid Control > Utility
(e) Start the engine. (f) Enter the following menus: Powertrain / Engine / Active Test / Control the Exhaust VVT OCV Duty Ratio Bank 1. Powertrain > Engine > Active Test
(g) According to the display on the Techstream, perform the Active Test and check the engine speed while operating the cam timing oil control solenoid assembly. Standard Condition:
HINT:
If the result is not as specified, check the cam timing oil control solenoid assembly, wire harness and ECM. |
Toyota Avalon Service & Repair Manual > Lighting System(for Gasoline Model With Cornering Light): Initialization
INITIALIZATION NOTICE: The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed or replaced during headlight ECU sub-assembly LH removal/installation are shown below. Replaced Part or Performed Procedure Necessary ...