Toyota Avalon Service & Repair Manual: Navigation Processor Malfunction (B15AD)

DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation ECU.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

B15AD

Navigation Processor Malfunction

When either condition below is met:

  • A short to ground, short to +B or open occurs in the gyro signal circuit
  • Gyro sensor malfunction

Navigation ECU

CAUTION / NOTICE / HINT

NOTICE:

When replacing the navigation ECU, always replace it with a new one. If a navigation ECU which was installed to another vehicle is used, the following may occur:

  • A communication malfunction DTC may be stored.
  • The navigation ECU may not operate normally.

PROCEDURE

1.

CHECK DTC

(a) Clear the DTCs.

Body Electrical > Navigation System > Clear DTCs

(b) Recheck for DTCs and check that no DTCs are output.

Body Electrical > Navigation System > Trouble Codes

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

REPLACE NAVIGATION ECU

    Stereo Component Amplifier Malfunction (B15A3)

    GPS Antenna Connection Malfunction(short) (B15C0,B15C1)

    See More:

    Toyota Avalon Service & Repair Manual > Automatic Transaxle System: Pressure Control Solenoid "B" Actuator Stuck Off (P07757F)
    DESCRIPTION Based on signals from the transmission revolution sensors (NT and NC), the actual gear is detected. The ECM compares the actual gear with the shift schedule in the ECM memory to detect mechanical malfunctions of the solenoid valves, transmission valve body assembly and automatic transaxl ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2023 Copyright www.tavalon.net
    0.011