DESCRIPTION The blind spot monitor sensor receives vehicle speed signals from the skid control ECU via CAN communication. Blind Spot Monitor Master
CAUTION / NOTICE / HINT NOTICE: When checking for DTCs, make sure that the blind spot monitor system is turned on. PROCEDURE
(a) Turn the engine switch off. (b) Connect the Techstream to the DLC3. (c) Turn the engine switch on (IG). (d) Turn the Techstream on. (e) Read the DTCs following the prompts on the Techstream. Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes. Chassis > ABS/VSC/TRAC > Trouble CodesOK: Electronically controlled brake system DTCs are not output.
(a) Turn the engine switch off. (b) Turn the engine switch on (IG). (c) Recheck for DTCs and check if the same DTC is output again. Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes
|
Toyota Avalon Service & Repair Manual > Hood Lock Control Cable Assembly: Components
COMPONENTS ILLUSTRATION *1 COOL AIR INTAKE DUCT SEAL *2 FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH *3 FRONT WHEEL OPENING EXTENSION PAD LH *4 HOOD LOCK ASSEMBLY *5 HOOD LOCK NUT CAP - - N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part MP grease - - ILLUSTRATION *1 COWL SIDE TRIM SUB-ASS ...