Toyota Avalon Service & Repair Manual: RCTB Sensor (C1AF7)

Toyota Avalon Service & Repair Manual / Audio, Visual, Telematics / Park Assist / Monitoring / Intelligent Clearance Sonar System(for Gasoline Model) / RCTB Sensor (C1AF7)

DESCRIPTION

This DTC is stored when the clearance warning ECU assembly receives a signal from the blind spot monitor system via CAN communication indicating a malfunction in the blind spot monitor sensor.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1AF7

RCTB Sensor

Blind spot monitor sensor malfunction

Blind spot monitor system

PROCEDURE

1.

CHECK FOR DTC

(a) Using the Techstream, check for DTCs according to the prompts on the screen.

HINT:

After turning the engine switch from off to on (IG), wait 4 seconds or more before checking for DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes

(b) Clear the DTCs according to the screen on the Techstream.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs

(c) Recheck for DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes

HINT:

  • DTC C1AF7 is stored when a malfunction signal sent from the blind spot monitor system is detected.
  • If the malfunctioning part has been repaired or replaced before rechecking for DTCs, DTC C1AF7 will not be output again.
  • If DTC C1AF7 is output frequently, duplicate the conditions that cause the problem symptoms and perform troubleshooting again, even though the DTC was not output when rechecking for DTCs.

Result

Proceed to

DTC C1AF7 is output

A

DTC C1AF7 is not output

B
A

GO TO BLIND SPOT MONITOR SYSTEM

B

USE SIMULATION METHOD TO CHECK

    Rr Sensor Initialization Incomplete (C1AF4)

    Blind Spot Monitor Beam Axis Inspection Incomplete (C1AF9)

    See More:

    Toyota Avalon Service & Repair Manual > Audio And Visual System(for Hv Model): Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
    DESCRIPTION The stereo jack adapter assembly sends the sound signal from an external device to the radio and display receiver assembly via this circuit. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO JACK ADAPTER ASSEMBLY) (a) Disconnect the G3 ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2022 Copyright www.tavalon.net
    0.0148