CAUTION / NOTICE / HINT
HINT:
- Use the following procedure to troubleshoot the panoramic view monitor system.
- *: Use the Techstream.
PROCEDURE |
1. | VEHICLE BROUGHT TO WORKSHOP |
|
NEXT |
 | |
| 2. |
INSPECT AUXILIARY BATTERY VOLTAGE | (a) Measure the auxiliary battery voltage with power switch off.
Standard Voltage: 11 to 14 V If the voltage is below 11 V, replace or recharge the auxiliary battery before proceeding.
|
NEXT | |
| |
| 3. |
CHECK NAVIGATION SYSTEM | (a) Refer to Navigation System.
Click here  OK: Navigation system is normal.
| NG |
 | GO TO NAVIGATION SYSTEM |
|
OK | |
| |
| 4. |
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
(a) Use the Techstream to check if the CAN communication system is functioning normally.
Click here
|
Result | Proceed to | |
CAN DTCs are not output |
A | | CAN DTCs are output |
B |
| B |
| GO TO CAN COMMUNICATION SYSTEM |
|
A | |
| |
(a) Check for DTCs and note any codes that are output. Chassis > Panoramic View Monitor > Trouble Codes
(b) Clear the DTCs. Chassis > Panoramic View Monitor > Clear DTCs
(c) Recheck for DTCs. Try to reproduce the DTCs by simulating the original activity that the DTC suggests. Chassis > Panoramic View Monitor > Trouble Codes
|
Result | Proceed to | |
DTCs are not output | A | |
DTCs are output | B |
| B |
| GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
A | |
| |
| 6. |
PROBLEM SYMPTOMS TABLE | (a) Refer to the Problem Symptoms Table.
Click here
|
Result | Proceed to | |
Fault is not listed in Problem Symptoms Table |
A | | Fault is listed in Problem Symptoms Table |
B |
| B |
| GO TO STEP 8 |
|
A | |
| |
| 7. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Data List / Active Test Click here
(b) Terminals of ECU Click here
|
NEXT | |
| |
| 8. |
ADJUST, REPAIR OR REPLACE |
|
NEXT | |
| |
| NEXT |
| END | | 
