Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

If there are no DTCs output and the problem still occurs, check the suspected areas for each problem symptom in the order given in the following table and proceed to the relevant troubleshooting page.

NOTICE:

When replacing the skid control ECU (brake actuator assembly), sensors, etc., turn the engine switch off.

HINT:

  • Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  • Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Vehicle Stability Control System

Symptom

Suspected Area

Link

ABS warning light abnormal (Remains on)

Refer to the procedure for "ABS Warning Light Remains ON"

ABS warning light abnormal (Does not come on)

Refer to the procedure for "ABS Warning Light does not Come ON"

Brake system warning light (red indicator) abnormal (Remains on)

Refer to the procedure for "Brake Warning Light Remains ON"

Brake system warning light (red indicator) abnormal (Does not come on)

Refer to the procedure for "Brake Warning Light does not Come ON"

Brake hold standby indicator light abnormal

Refer to the procedure for "Brake Hold Standby Indicator Light Circuit"

Brake hold operated indicator light abnormal

Refer to the procedure for "Brake Hold Operated Indicator Light Circuit"

Slip indicator light abnormal (Remains on)

Refer to the procedure for "Slip Indicator Light Remains ON"

Slip indicator light abnormal (Does not come on)

Refer to the procedure for "Slip Indicator Light does not Come ON"

TRAC does not operate

Refer to the procedure for "TRAC does not Operate"

Excessive brake pedal travel (No fluid leaks and no air in system)

Refer to the procedure for "Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)"

ABS operates before necessary when braking

Refer to the procedure for "ABS Operates Before Necessary When Braking"

VSC does not operate or VSC does not operate correctly

Refer to the procedure for "VSC does not Operate or VSC does not Operate Correctly"

Brake actuator operation sound is loud during initial check

Refer to the procedure for "Brake Actuator Operation Sound is Loud during Initial Check"

VSC OFF switch abnormal

Refer to the procedure for "VSC OFF Switch Circuit"

    Precaution

    Slip Indicator Light does not Come ON

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Safety Connect System(for Gasoline Model): Initialization
    INITIALIZATION RESET BUB (BACK-UP BATTERY) CONDITION HINT: If the BUB (Back-Up Battery) has been replaced, it is necessary to perform this procedure. (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0118