INSTALLATION PROCEDURE 1. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY (a) Install a new gasket to the water inlet with thermostat sub-assembly. (b) Install the water inlet with thermostat sub-assembly with the 2 bolts and 2 nuts. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} 2. CONNECT WATER BY-PASS HOSE (a) Connect the water by-pass hose and slide the clip to secure it. 3. INSTALL FRONT NO. 1 ENGINE MOUNTING BRACKET LH Click here 4. CONNECT ENGINE WIRE (a) Engage the clamp to connect the engine wire. (b) Install the bolt. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} (c) Connect the water inlet with thermostat sub-assembly connector. 5. INSTALL NO. 2 ENGINE MOUNTING STAY RH (a) Install the No. 2 engine mounting stay RH to the intake manifold and front No. 1 engine mounting bracket LH with the bolt. Torque: 21 N·m {214 kgf·cm, 15 ft·lbf} (b) Connect the wire harness clamp bracket to the No. 2 engine mounting stay RH with the bolt. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} (c) Connect the wire harness clamp to the wire harness clamp bracket with the bolt. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} 6. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE Click here |
Toyota Avalon Service & Repair Manual > Steering Gear(for Hv Model): Components
COMPONENTS ILLUSTRATION *1 FRONT WHEEL OPENING EXTENSION PAD LH *2 FRONT WHEEL OPENING EXTENSION PAD RH *3 NO. 1 ENGINE UNDER COVER *4 NO. 2 ENGINE UNDER COVER ASSEMBLY *5 STEERING INTERMEDIATE SHAFT ASSEMBLY *6 TIE ROD ASSEMBLY LH *7 COTTER PIN - - Tightening torque for "Major areas involving basic ...
