DESCRIPTION This DTC is set when the DCM (Telematics Transceiver) detects one of the following:
CAUTION / NOTICE / HINT HINT: Before performing this diagnostic procedure, make sure to perform Health Check and confirm that the DCM/VIN registration information is correct. Click here
PROCEDURE
(a) Turn the engine switch off. (b) Connect the Techstream to the DLC3. (c) Turn the engine switch on (IG) and wait for 10 seconds. (d) Turn the Techstream on. (e) Clear the DTCs. Body Electrical > Telematics > Clear DTCs(f) Recheck for DTCs. Body Electrical > Telematics > Trouble Codes
(a) Replace the BUB (Back-Up Battery) with a known good one and check if the same problem occurs again. Click here NOTICE: The BUB (Back-Up Battery) must not be replaced while an ACN call is in progress. Click here
(a) Clear the DTCs. Click here
(a) Recheck for DTCs and check if the same trouble occurs again. Click here OK: No DTC is output.
(a) Replace the DCM (Telematics Transceiver). Click here NOTICE:
|
Toyota Avalon Service & Repair Manual > Audio And Visual System(for Hv Model): Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
DESCRIPTION The stereo jack adapter assembly sends the sound signal from an external device to the radio and display receiver assembly via this circuit. WIRING DIAGRAM PROCEDURE 1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO JACK ADAPTER ASSEMBLY) (a) Disconnect the G3 ...