INSTALLATION PROCEDURE 1. INSTALL NO. 5 ANTENNA CORD SUB-ASSEMBLY (w/ Navigation System) (a) Connect the connector to install the No. 5 antenna cord sub-assembly. (b) Engage the clamp. 2. INSTALL NAVIGATION ECU WITH BRACKET (w/ Navigation System) Click here 3. INSTALL NO. 5 ANTENNA CORD SUB-ASSEMBLY (w/o Navigation System) (a) Connect the connector to install the No. 5 antenna cord sub-assembly. 4. INSTALL NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY Click here 5. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET Click here 6. INSTALL CENTER NO. 2 INSTRUMENT CLUSTER FINISH PANEL Click here 7. INSTALL CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL Click here 8. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Click here 9. INSTALL CONSOLE BOX POCKET SUB-ASSEMBLY Click here 10. INSTALL FRONT CONSOLE UPPER PANEL GARNISH Click here 11. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL RH Click here 12. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH Click here |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Active Noise Control System: Power Source Circuit
DESCRIPTION This circuit is the power source circuit for the stereo component equalizer assembly. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses and relays for circuits related to this system before performing the following procedure. PROCEDURE 1. CHECK HARNESS AND CONNECTOR (STERE ...