Toyota Avalon Service & Repair Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

NOTICE:

  • Avoid any impact to the blind spot monitor sensor.
  • Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.

HINT:

  • The blind spot monitor beam axis confirmation is performed to confirm whether the sensor beam axis is correct, and to adjust the beam axis by using a reflector.
  • The blind spot monitor sensor installation condition inspection is performed to confirm whether the sensor is perpendicular to the floor surface (+/-5°) by using a jig, and that the sensor is 46 to 54° from the line parallel to the vehicle center line.

PROCEDURE

1. INSTALL BLIND SPOT MONITOR SENSOR LH

(a) Connect the connector.

(b) Install the blind spot monitor sensor LH with the 3 nuts.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

2. INSTALL BLIND SPOT MONITOR SENSOR RH

(a) Connect the connector.

(b) Install the blind spot monitor sensor RH with the 3 nuts.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

3. PERFORM BLIND SPOT MONITOR SENSOR INSTALLATION CONDITION INSPECTION

Click here

4. INSTALL REAR BUMPER ASSEMBLY

Click here

5. PERFORM BLIND SPOT MONITOR BEAM AXIS CONFIRMATION

Click here

6. PERFORM DIAGNOSTIC SYSTEM CHECK

for Gasoline Model: Click here

for HV Model: Click here

    Components

    Removal

    See More:

    Toyota Avalon Service & Repair Manual > Automatic Light Control Sensor: On-vehicle Inspection
    ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR (a) Disconnect the G23 automatic light control sensor connector. *a Front view of wire harness connector (to Automatic Light Control Sensor) (b) Measure the voltage and resistance according to the value(s) in the table below. ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2023 Copyright www.tavalon.net
    0.0161