Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Destination Information Undefined (C1AB8)

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual / Audio, Visual, Telematics / Park Assist / Monitoring / Blind Spot Monitor System(for Gasoline Model) / Destination Information Undefined (C1AB8)

DESCRIPTION

This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot monitor sensor has been replaced.

Blind Spot Monitor Master

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1AB8

Destination Information Undefined

The blind spot monitor sensor cannot communicate with the main body ECU
  • CAN communication system
  • Main body ECU (multiplex network body ECU)
  • Blind spot monitor sensor RH
Blind Spot Monitor Slave

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1AB8

Destination Information Undefined

The blind spot monitor sensor cannot communicate with the main body ECU
  • CAN communication system
  • Main body ECU (multiplex network body ECU)
  • Blind spot monitor sensor LH

CAUTION / NOTICE / HINT

NOTICE:

  • When checking for DTCs, make sure that the blind spot monitor system is turned on.
  • Before replacing the main body ECU (multiplex network body ECU), refer to Registration.

    w/ Smart Key System: Click here

PROCEDURE

1.

CHECK DTC

(a) Check for CAN communication system DTCs.

Click here

OK:

CAN communication system DTCs are not output.

NG

GO TO CAN COMMUNICATION SYSTEM

OK

2.

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

(a) Replace the main body ECU (multiplex network body ECU) with a new or known good one.

Click here

NEXT

3.

RECHECK DTC

(a) Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes

Result

Proceed to

No DTCs are output

A

DTC C1AB8 is output ("Blind Spot Monitor Master")

B

DTC C1AB8 is output ("Blind Spot Monitor Slave")

C
A

END
B

REPLACE BLIND SPOT MONITOR SENSOR RH

C

REPLACE BLIND SPOT MONITOR SENSOR LH

    Blind Spot Monitor Slave Module (C1AB7)

    Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Canister: Components
    COMPONENTS ILLUSTRATION *1 FRONT FLOOR COVER LH *2 FRONT FLOOR COVER RH N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 CENTER FLOOR CROSSMEMBER BRACE *2 FRONT CENTER FLOOR BRACE N*m (kgf*cm, ft.*lbf): Specified torque - - ILLUSTRATION *1 CENTER EXHAUST PIPE ASSEMBLY *2 EXHAUST PIPE SUPP ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2025 Copyright www.tavalon.net
    0.0167