Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Lost Communication with ECM / PCM "A" (U0100,U0125,U0126,U0129,U0142)

DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the blind spot monitor sensor.

HINT:

If CAN communication system DTCs are stored, they may also be stored for other systems.

Blind Spot Monitor Master

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

U0100

Lost Communication with ECM / PCM "A"

Lost communication with ECM

CAN communication system

U0125

Lost Communication with Yaw Rate Sensor Module

Lost communication with airbag sensor assembly

CAN communication system

U0126

Lost Communication with Steering Angle Sensor Module

Lost communication with steering sensor

CAN communication system

U0129

Lost Communication with Brake System Control Module

Lost communication with brake system

CAN communication system

U0142

Lost Communication with Body Control Module "B"

Lost communication with main body ECU

CAN communication system

Blind Spot Monitor Slave

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

U0100

Lost Communication with ECM / PCM "A"

Lost communication with ECM

CAN communication system

U0125

Lost Communication with Yaw Rate Sensor Module

Lost communication with airbag sensor assembly

CAN communication system

U0126

Lost Communication with Steering Angle Sensor Module

Lost communication with steering sensor

CAN communication system

U0129

Lost Communication with Brake System Control Module

Lost communication with brake system

CAN communication system

U0142

Lost Communication with Body Control Module "B"

Lost communication with main body ECU

CAN communication system

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor system is turned on.

PROCEDURE

1.

CHECK DTC

(a) Turn the engine switch off.

(b) Turn the engine switch on (IG).

(c) Recheck for DTCs and check if the same DTC is output again.

Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes

Result

Proceed to

Blind Spot Monitor Master DTCs including DTC U0232 are output.

A

Blind Spot Monitor Master DTCs other than DTC U0232 are output.

B

No DTCs are output

C

HINT:

  • If CAN communication system DTCs are stored, they may also be stored for other systems.
  • If the CAN communication system has been inspected and repaired, the DTCs will not be output when rechecking for DTCs.
  • If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform troubleshooting again, even though the DTC was not output when rechecking for DTCs.

    Click here

A

GO TO DTC U0232

B

GO TO CAN COMMUNICATION SYSTEM

C

USE SIMULATION METHOD TO CHECK

    Terminals Of Ecu

    Lost Communication with Blind Spot Monitor Slave Module (U0232)

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Dynamic Radar Cruise Control System(for Gasoline Model): Front Radar Sensor (C1A10)
    DESCRIPTION The driving support ECU assembly uses the millimeter wave radar sensor assembly to detect obstacles in front of the vehicle. When the driving support ECU assembly receives information that there is a malfunction in the millimeter wave radar sensor assembly, DTC C1A10 is stored. DTC No. D ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0145