DESCRIPTION This DTC is stored if the television camera assembly judges that there is an internal malfunction as a result of its self check.
HINT: The
television camera assembly stores different types of information during
initialization. If the television camera assembly cannot read the
stored information when it is activated, the television camera assembly
judges that there is an internal malfunction and stores this DTC.
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
DTC Output from |
C1611 | ECU Malfunction |
When any of the following conditions is met:
- EEPROM status (Initial read) malfunction
- CPU communication malfunction
- Video output malfunction
| Television camera assembly |
Television camera assembly | CAUTION / NOTICE / HINT
NOTICE:
- When "!" is displayed on the radio and display receiver assembly after
the cable is disconnected from the negative (-) battery terminal,
correct the steering angle neutral point.
Click here
- Depending on the parts that are replaced or operations that are
performed during vehicle inspection or maintenance, calibration of other
systems as well as the panoramic view monitor system may be needed.
Click here
PROCEDURE
1. | READ VALUE USING TECHSTREAM |
(a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG).
(c) Turn the Techstream on. (d) Enter the following menus: Chassis / Parking Assist Camera / Data List.
(e) Read the Data List according to the display on the Techstream. Chassis > Parking Assist Camera > Data List
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note |
Video Output Status | Output condition of video signal |
OK or NG | OK: Output condition of video signal is normal
NG: Output condition of video signal is abnormal |
- | EEPROM Status (Initial read) |
Television camera assembly information |
OK or NG | OK: Television camera assembly normal
NG: Television camera assembly abnormal |
- | CPU Communication Status |
Television camera assembly information |
OK or NG | OK: Television camera assembly normal
NG: Television camera assembly abnormal |
- | Chassis > Parking Assist Camera > Data List
Tester Display | Video Output Status |
EEPROM Status (Initial read) |
CPU Communication Status |
Result | Proceed to |
OK is displayed for all items |
A | NG is displayed for EEPROM status (Initial read) |
NG is displayed for items other than EEPROM status (Initial read) |
B |
B |
| REPLACE TELEVISION CAMERA ASSEMBLY |
A |
| |
(a)
Perform the following procedure depending on the memory conditions to
register the vehicle information into the television camera assembly. (1) Television camera assembly optical axis adjustment (back camera position setting).
Click here (2) Steering angle setting.
Click here
NEXT |
| |
(a) Clear the DTCs. Chassis > Parking Assist Camera > Clear DTCs
(b) Recheck for DTCs and check that no DTCs are output. Chassis > Parking Assist Camera > Trouble Codes
HINT:
- If DTC C1611 is output, perform the procedure to allow the television camera assembly to store the vehicle information again.
- If DTC C1611 is still output after performing the procedure to make the
television camera assembly store the vehicle information 3 times,
replace the television camera assembly.
Result | Proceed to |
DTC C1611 is output | A |
DTC C1611 is not output |
B |
A |
| REPLACE TELEVISION CAMERA ASSEMBLY |
B |
| END | |