Toyota Avalon Service & Repair Manual: ECU Malfunction (C1611)

DESCRIPTION

This DTC is stored if the television camera assembly judges that there is an internal malfunction as a result of its self check.

HINT:

The television camera assembly stores different types of information during initialization. If the television camera assembly cannot read the stored information when it is activated, the television camera assembly judges that there is an internal malfunction and stores this DTC.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1611

ECU Malfunction

When one of the following conditions is met:

  • EEPROM status (Initial read) malfunction
  • CPU communication malfunction
  • Video output malfunction

Television camera assembly

CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

Click here

PROCEDURE

1.

READ VALUE USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Chassis / Parking Assist Camera / Data List.

(e) According to the display on the Techstream, read the Data List.

Chassis > Parking Assist Camera > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Video Output Status

Output condition of video signal

OK or NG

OK: Output condition of video signal is normal

NG: Output condition of video signal is abnormal

-

EEPROM Status (Initial read)

Television camera assembly information

OK or NG

OK: Television camera assembly normal

NG: Television camera assembly abnormal

-

CPU Communication Status

Television camera assembly information

OK or NG

OK: Television camera assembly normal

NG: Television camera assembly abnormal

-

Chassis > Parking Assist Camera > Data List

Tester Display

Video Output Status

EEPROM Status (Initial read)

CPU Communication Status

Result

Proceed to

OK is displayed for all items

A

NG is displayed for EEPROM status (Initial read)

NG is displayed for items other than EEPROM status (Initial read)

B

B

REPLACE TELEVISION CAMERA ASSEMBLY

A

2.

PERFORM CALIBRATION

(a) Perform the following procedure depending on the memory conditions to register the vehicle information into the television camera assembly.

(1) Television camera assembly optical axis adjustment (back camera position setting).

Click here

(2) Steering angle setting.

Click here

NEXT

3.

CHECK DTC OUTPUT

(a) Clear the DTCs.

Chassis > Parking Assist Camera > Clear DTCs

(b) Recheck for DTCs and check that no DTCs are output.

Chassis > Parking Assist Camera > Trouble Codes

HINT:

  • If DTC C1611 is output, perform the procedure to allow the television camera assembly to store the vehicle information again.
  • If DTC C1611 is still output after performing the procedure to make the television camera assembly store the vehicle information 3 times, replace the television camera assembly.

Result

Proceed to

DTC C1611 is output

A

DTC C1611 is not output

B

A

REPLACE TELEVISION CAMERA ASSEMBLY

B

END

    Vehicle Information Unmatched (C168D)

    Back Camera Power Supply Failure (C1621)

    See More:

    Toyota Avalon Service & Repair Manual > Hybrid Control System: ECM/PCM Power Relay Sense Circuit Intermittent (P06881F)
    DESCRIPTION This DTC indicates that the hybrid vehicle control ECU detected an instantaneous interruption in +B power source voltage. DTC No. Detection Item DTC Detection Condition Trouble Area MIL Warning Indicate P06881F ECM/PCM Power Relay Sense Circuit Intermittent When the power switch is on (R ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0139