DESCRIPTION Troubleshooting for when ABS operates too soon due to a noisy signal from the speed sensor, a difference in output, etc. PROCEDURE
(a) Enter the following menus: Chassis / ABS/VSC/TRAC/EPB / Utility / Signal Check. (b) Using the Techstream, perform a Test Mode (Signal Check) inspection sensor check and check that speed sensor Test Mode (Signal Check) inspection items change from incomplete to complete. Click here Chassis > ABS/VSC/TRAC/EPB > Utility
OK: Speed sensor Test Mode (Signal Check) inspection items change from incomplete to complete.
NOTICE:
HINT: The rear speed sensor and rear speed sensor rotor are incorporated into the rear axle hub and bearing assembly. If the rear speed sensor and rear speed sensor rotor need to be replaced, replace the rear axle hub and bearing assembly.
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Front Drive Shaft Assembly: Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL FRONT DRIVE SHAFT HOLE SNAP RING (a) Install a new front drive shaft hole snap ring. NOTICE: Face the end gap of the front drive shaft hole ...