DESCRIPTION The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE: When replacing the skid control ECU (brake actuator assembly), perform system variant learning and acceleration sensor zero point calibration. Click here
PROCEDURE
(a) Check if CAN communication system DTCs are output. Click here
(a) Enter the following menus: Chassis / ABS/VSC/TRAC/EPB / Active Test. Chassis > ABS/VSC/TRAC/EPB > Active Test
(b) Check the operating condition of the ABS warning light when operating it using the Techstream.
(a) Enter the following menus: Body Electrical / Combination Meter / Active Test. (b) Perform the Active Test of the combination meter assembly using the Techstream. Body Electrical > Combination Meter > Active Test
(c) Check the combination meter assembly. OK: The ABS warning light turns on or off in accordance with Techstream operation.
|
Toyota Avalon Service & Repair Manual > Toyota Entune System(for Gasoline Model): Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: When replacing the radio receiver assembly or navigation ECU, always replace it with a new one. If a radio receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur: A communication malfunction DTC may be stored. The ra ...